PART THREE

THE GOLF INDUSTRY IS STILL MAKING SHAFTS BY HAND?

< Read Part 2Read Part 4 >

There are certain things in our life that we want to be made “by hand.” We’re Swiss, so we’re particular about the craftsmanship of our watches. Maybe you prefer Italian leather shoes or Japanese denim jeans? You get the point.

One thing we don’t think anyone should want is a handmade golf shaft, yet that’s how nearly all graphite shafts are made today. Conventional golf shafts are created through a process known as the “roll-wrapping method.” To make a shaft, a shaftmaker places what’s known as a “flag” of shaft material over a mandrel, which is the steel bar that sets the internal diameter of a shaft. He or she will place these flags onto the mandrel by hand, “rolling” and “wrapping” them into position one by one.

The video below shows the process one of our competitors uses to create its shafts with the roll-wrapping method.

Conventional shafts are made of these different pieces because it’s a way to change the profile of a shaft. For example, stiffer material may be added to the tip section of a shaft to lower trajectory and reduce torque. But as each piece is added by hand, the shaft becomes less precise and more inconsistent. One reason for this is the margin of error that exists even for the most experienced shaftmaker. The second reason has to do with the orientation of the shaft fibers and how they change during the roll-wrapping process.

Think back to the example of gift-wrapping a megaphone. As you wrap the paper around the megaphone, the angle of the paper changes as overlap occurs. The same thing happens when you wrap shaft material over a mandrel. Because the mandrel is tapered like a megaphone, the orientation of the fibers changes as the material is wrapped around it.

To control torque in a golf shaft, for example, the most desirable fiber angle is +/- 45 degrees. This “X” orientation increases torsional stiffness, thus reducing shaft torque. As a general rule of thumb, the more +/- 45-degree angle fibers in a shaft, the lower the overall shaft torque will be.

The problem is that in the roll-wrapping method, fiber angles can shift 10 degrees or more by the time they’re wrapped all the way around the mandrel. This weakens the material, and the fix is to apply additional layers of material to create the desired stiffness. And as you add more layers in the roll-wrapping method, you also add more areas of overlap, which further reduces consistency and performance.

When we were developing TPT Golf shafts, we knew we didn’t want to leave any room for human error. We needed to create a manufacturing process that would allow us to maintain the precise orientation of our fibers around the shaft.

That’s why from the start, a fully automated method was the only choice. The manufacturing of our shafts had to be driven by advanced machinery and robotics. That way, we could ensure the consistency of every shaft we made and create a new standard of performance.

CONTINUE READING

READ OTHER PARTS OF THIS SERIES

PART ONE

The Beginning: From the Seas To The Links

READ NOW

PART TWO

The Problem With Graphite Shafts

READ NOW

PART FOUR

The Best Material Is Only The Start

READ NOW

PART FIVE

Creating A Better Golf Shaft

READ NOW